Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
1. Maintenance instruction
2. Maintenance
2.1. Specifications
2.2. Service through each 15000 km or 6 months
2.3. Service through each 30000 km or 12 months
2.4. Service through each 60000 km or 2 years
2.4.1. Replacement of the air filter
2.4.2. Check of system of ignition
2.4.3. Replacement of the filter of ventilation of a case
2.4.4. Check of a hose and control vacuum amplifier
2.4.5. Replacement of cooling liquid
2.4.6. Replacement of transmission liquid in automatic transmission
2.5. Service through each 60000 km or 12 months
3. Engines
4. Cooling system
5. System of heating and ventilation
6. Fuel and exhaust system
7. System of launch of the engine
8. Coupling
9. Transmissions
10. Half shafts
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







2-4-5-zamena-okhlazhdayushhejj-zhidkosti.html

2.4.5. Replacement of cooling liquid


Prevention

The procedure is performed on completely cooled down engine, with observance of security measures of work with poisonous liquids.


PERFORMANCE ORDER
1. Carefully turn off a radiator stopper, having wrapped up a tampon from rags.
2. Transfer a rychazhok of management of a heater to situation "hot".
3. Turn off a drain stopper of a radiator (it is specified by an arrow).
4. Merge liquid in a vessel, having taken measures that liquid did not get on belts of the drive or on rubber details.
5. If necessary remove a broad tank, merge the remains of liquid and wash out.
6. Substitute a vessel under a drain stopper of the block of cylinders (it is specified by an arrow).
7. Turn off a stopper on the block of cylinders, then turn off the union for removal of air (the union is specified by an arrow). Merge liquid from the block of cylinders.
8. Wrap a drain stopper, fill in clear water in a radiator. After it is watered from the engine turn and tighten a drain stopper of the block of cylinders.
9. Continue to fill in water until water does not begin to flow from openings for removal of air. Wrap caps of openings and tighten with the set moment.
10. Add water to mark MOVE of a broad tank, densely wrap a radiator mouth stopper.
11. Start the engine and warm up until the auxiliary fan of the cooling system turns on. Bring 2–3 times turns to 3000 rpm, stop the engine and wait for full cooling.
12. Repeat actions in subitem 3-11 until the following water does not become pure.
13. Merge water and repeat actions in subitem 8-10, but this time fill in antifreeze in the necessary proportion. Grease a drain stopper of the block of cylinders with the fixing structure and tighten with the set moment.
14. Start the engine and warm up up to the working temperature, stop the engine and wait for full cooling.
15. Be convinced of lack of a leak from under the understanding connections. Check liquid level in a broad tank, if necessary add.


2.4.4. Check of a hose and control vacuum amplifier

2.4.6. Replacement of transmission liquid in automatic transmission