Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
	1. Maintenance instruction
		1.1. Control panel
		1.2. Alarm lamps
		1.3. Arrangement of identification plates
		1.4. The AM-UKV radio receiver with electronic control
		1.5. The AM-VHF-radio tape recorder with electronic control
		1.6. Catalyst
		1.7. Keys
		1.8. Ignition switch and lock of ignition
		1.9. Handle of management of a screen wiper and washer of a windshield
		1.10. The combined switch of driving and passing beam
		1.11. Heating of back glass and side mirrors
		1.12. Possible malfunctions
			1.12.1. Start of the engine from the auxiliary battery
			1.12.2. Replacement of a wheel
			1.12.3. Detection of the place of a leak
			1.12.4. Weekly checks
			1.12.5. Check and restoration of level of liquid of a hydraulic actuator of brakes
			1.12.6. Replacement of lamps and safety locks
			1.12.7. The recommended lubricants and liquids
	2. Maintenance
	3. Engines
	4. Cooling system
	5. System of heating and ventilation
	6. Fuel and exhaust system
	7. System of launch of the engine
	8. Coupling
	9. Transmissions
	10. Half shafts
	11. Brakes
	12. Suspension brackets and steering
	13. Body
	14. Electric equipment

1-12-2-zamena-kolesa.html

1.12.2. Replacement of a wheel

The replacement procedure of a wheel is identical to all cars.

Preparation

PERFORMANCE ORDER

1. At a wheel puncture immediately stop the car, considering traffic conditions.

2. Install the car on a plain firm surface on sufficient removal from a lane.

3. If necessary include a signal of an emergency stop.

4. If there is a sign of an emergency stop, then establish it for the prevention of other drivers.

5. Put the car on the parking brake and turn on the first or reverse gear (situation Park in cars with automatic transmission).

6. Block a wheel diagonalno opposite to replaced.

7. In order to avoid immersion of a jack to the soft soil substitute under it a board.

Wheel replacement procedure

PERFORMANCE ORDER

	1. Get a jack. The jack is strengthened on the right side of a luggage carrier, under the hatch.
	2. The spare wheel and the tool are in a niche in a luggage compartment, under a decorative slip. Turn off the holder, get a spare wheel, hook and take off a decorative cap.
	3. Weaken nuts of fastening of the replaced wheel.
	4. Establish a jack under the strengthened body threshold section, rotate the jack handle clockwise until the wheel is not raised above the ground. As the handle are used the holder of a wheel and mount for removal of a decorative cap.
	5. Turn off nuts and remove a wheel.
	6. Establish a spare wheel, turn and tighten fastening nuts. Check an inhaling of nuts after lowering of the car.
	7. Establish a decorative cap so that the gate of a wheel was opposite to its cast image on a cap.

After replacement of a wheel

PERFORMANCE ORDER

1. Remove from under a block wheel.

2. Put a jack and tools in a luggage carrier, observing correctness of placement.

3. Check pressure in the tire of the established wheel. If pressure low or you have no manometer, then, moving at a small speed, reach the next garage and pump up the tire up to the normal pressure.

4. Immediately take the damaged wheel (or the tire) to repare.

1.12.1. Start of the engine from the auxiliary battery

1.12.3. Detection of the place of a leak