Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
	1. Maintenance instruction
		1.1. Control panel
		1.2. Alarm lamps
		1.3. Arrangement of identification plates
		1.4. The AM-UKV radio receiver with electronic control
		1.5. The AM-VHF-radio tape recorder with electronic control
		1.6. Catalyst
		1.7. Keys
		1.8. Ignition switch and lock of ignition
		1.9. Handle of management of a screen wiper and washer of a windshield
		1.10. The combined switch of driving and passing beam
		1.11. Heating of back glass and side mirrors
		1.12. Possible malfunctions
			1.12.1. Start of the engine from the auxiliary battery
			1.12.2. Replacement of a wheel
			1.12.3. Detection of the place of a leak
			1.12.4. Weekly checks
			1.12.5. Check and restoration of level of liquid of a hydraulic actuator of brakes
			1.12.6. Replacement of lamps and safety locks
			1.12.7. The recommended lubricants and liquids
	2. Maintenance
	3. Engines
	4. Cooling system
	5. System of heating and ventilation
	6. Fuel and exhaust system
	7. System of launch of the engine
	8. Coupling
	9. Transmissions
	10. Half shafts
	11. Brakes
	12. Suspension brackets and steering
	13. Body
	14. Electric equipment

1-12-6-zamena-lamp-i-predokhranitelejj.html

1.12.6. Replacement of lamps and safety locks

PERFORMANCE ORDER

	1. If do not burn one of headlights, a dimensional lamp or a signal of braking, then the pergoraniye of lamps is the most probable cause. A replacement procedure of lamps see in subsection 14.5. If both signals of braking do not burn, then malfunction of the switch is the reason.
	2. If several control lamps, headlights, dimensional or back lamps do not burn, then the safety lock fused or conducting is faulty (see subsection 14.3). Safety locks are in a block on the forward panel from the driver.
	3. Additional safety locks and breakers are in the assembly blocks mounted in a motor compartment on the right and at the left.
	4. For replacement of a safety lock open a cover, having overcome effort of latches. pull for built-in the plastic holder and get a safety lock. Insert the new safety lock calculated on the same current, as replaced. Find out the reason of burn-out and eliminate.