|
4-7-nasos-okhlazhdayushhejj-zhidkosti.html
4.7. Pump of cooling liquidRemoval
| PERFORMANCE ORDER |
| 1. Disconnect the battery from weight. |
| 2. Merge cooling liquid. |
| 3. Take off all belts. |
|
4. Record a pulley of the pump of cooling liquid, having wrapped up an old belt, turn off bolts and remove a pulley. |
| 5. Unscrew the case of the thermostat and carefully displace aside, without having damaged conducting. If necessary disconnect hoses and wires. |
|
6. Turn off bolts and remove the pump, having carefully knocked or having loosened to destroy consolidation. |
|
Check
| PERFORMANCE ORDER |
| 1. Check a condition of the case and a krylchatka, radial and axial side plays of the roller of the pump, freedom of rotation of a krylchatka. |
| 2. The pump is not subject to dismantling and is replaced as the uniform unit. |
|
Installation
| PERFORMANCE ORDER |
| 1. Clear the pump, the demountable plane of the block of cylinders and the case of the thermostat. |
|
|
| 2. Apply sealant on the demountable surfaces of the pump (at the left – the pump with the block of cylinders, on the right – the pump with the thermostat case). |
| 3. Install the pump and tighten bolts with the set moment. |
|
4. Grease carvings of two lower bolts with the fixing structure. |
| 5. Establish a pulley, tighten bolts with the set moment. |
| 6. Apply sealant on the demountable surface of the case of the thermostat |
| 7. Install the thermostat on the pump, tighten bolts with the set moment. |
| 8. Put on belts, adjust a tension. |
| 9. Fill in liquid. |
| 10. Connect the battery to weight. |
|
|
|