| 1. Disconnect the socket in the top part of a case and check a chain between sensor conclusions. |
| 2. Contacts of the sensor have to be closed only at neutral position of the lever. |
| 3. Otherwise check conducting. |
| 4. If conducting is correct, then replace the sensor. |
| 5. To remove the sensor lift a back part of the car and establish on supports, merge oil from the check point. |
| 6. Disconnect the sensor socket from a plait. |
| 7. Turn out the sensor. |
| 8. Clear a carving of a case and grease a carving of the new sensor with sealant. |
| 9. Screw the sensor. |
| 10. Tighten the sensor and attach the socket. |
| 11. Lower the car, fill in oil in the check point. |