Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
	1. Maintenance instruction
	2. Maintenance
	3. Engines
	4. Cooling system
	5. System of heating and ventilation
	6. Fuel and exhaust system
	7. System of launch of the engine
	8. Coupling
	9. Transmissions
		9.1. Mechanical transmission
			9.1.1. Specifications
			9.1.2. Mechanism of change of transfers
			9.1.3. Epiploons
			9.1.4. Sensor of neutral situation
			9.1.5. Backing signal switch
			9.1.6. Speedometer reducer
		9.2. Automatic transmission
	10. Half shafts
	11. Brakes
	12. Suspension brackets and steering
	13. Body
	14. Electric equipment

9-1-6-reduktor-spidometra.html

9.1.6. Speedometer reducer

The reducer of a speedometer is near the right half shaft.

Removal

PERFORMANCE ORDER

1. Lift a back part of the car and establish on supports.
2. Turn off a cap nut and disconnect a speedometer cable.
	3. Turn off a bolt.
	4. Get a reducer and a sealing ring.
	5. If necessary beat out a pin, remove a gear wheel and a persistent washer (shooters specified a pin and a sealing ring).
6. Check all details.
7. Replace a sealing ring.
8. If it is necessary to replace a persistent washer, then keep in mind that thickness of a new washer has to be equal to thickness replaced.
9. At detection of defects of a gear wheel of a reducer check also a condition of the leading gear wheel in the check point.
10. For replacement of the leading gear wheel of a reducer it is necessary to sort the check point and to remove differential therefore these works should be performed in service of car service.

Installation

PERFORMANCE ORDER

1. Collect a reducer and press a new pin.

2. Replace a sealing ring, establish a reducer at the check point and tighten a bolt.

3. Attach a speedometer cable, wrap a nut.

4. Lower the car.