|
9-2-2-tros-upravleniya-transmissiejj.html
9.2.2. Cable of management of transmission
Cable of management of transmission
|
1. Selector
2. Fastening of a cable to a floor
3. Floor
4. Cable
|
5. Arm
6. Arm
7. Cable cover nut
8. Transmission lever |
Adjustment of a cable
|
|
1. Lever
2. Cable
3. Nut
4. The blocking starter switch
The arrow specified the direction of effort at adjustment. |
Adjustment
| PERFORMANCE ORDER |
| 1. Transfer the selector to situation P. |
| 2. Lift a forward part of the car and establish on supports. |
| 3. Make sure that the transmission lever is in situation P too. |
| 4. Turn off a nut of fastening of a cable to the lever. |
| 5. Pull a dynamometer for a cable tip eye with a force of 0,7 kgfs. |
| 6. Remove a dynamometer and displace a cable back on 1,0 mm. |
| 7. Holding a cable cover, tighten a lock-nut. |
| 8. Check freedom of movement of the selector. |
| 9. If when moving the selector the cable is bent, then repeat adjustment. |
| 10. Grease the rubbing surfaces of a cable and the lever and lower the car. |
|
Removal
| PERFORMANCE ORDER |
| 1. Lift a forward part of the car and establish on supports. |
| 2. Transfer the selector to situation P. |
| 3. Remove the central section of the forward panel. |
| 4. Turn off a nut, get a bracket of a cover of a cable and disconnect a cable from the selector. |
| 5. Turn off a bolt and remove an arm, extend a cable. |
| 6. Turn off a nut on the lever, get a bracket from an arm and remove a cable. Keep in mind that position of the lever on transmission at installation of a cable should not change (designate position of the lever before removal of a cable). |
| 7. Check existence on a cable of wear tracks and damages. |
| 8. Check freedom of movement of a cable in a cover. Keep in mind that at installation into place the cable can jam, despite the seeming ease of its movement in completely straightened state. |
| 9. At strong damages replace a cable. |
|
Installation
| PERFORMANCE ORDER |
| 1. Pass a cable through a floor and tighten fastening bolts to a floor. |
| 2. Attach a cable to the selector and insert a cable cover into an arm. |
| 3. Tighten a nut and insert a bracket. |
| 4. Transfer the selector to situation P, be convinced that the transmission lever is in situation P too. |
| 5. Put on a cable the transmission lever. |
| 6. Fix a cable cover by brackets. |
| 7. Adjust a cable. |
| 8. Establish the central section of the forward panel, lower the car. |
|
|
|