Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
1. Maintenance instruction
2. Maintenance
2.1. Specifications
2.2. Service through each 15000 km or 6 months
2.3. Service through each 30000 km or 12 months
2.3.1. Check and replacement of belts of the drive of auxiliary units
2.3.2. Replacement of the fuel filter
2.3.3. Replacement of spark plugs (the car without Catholic converter)
2.3.4. Check of operation of the gate of a temperature regulator of the air filter
2.3.5. Check of system of decrease in toxicity of the fulfilled gases
2.3.6. Check of the sensor of exhaust gases
2.3.7. Replacement of brake fluid
2.3.8. Check of a suspension bracket and steering
2.3.9. Check of covers of half shafts
2.3.10. Check of the exhaust system
2.3.11. Check of angles of installation of wheels
2.3.12. Shift of wheels
2.3.13. Check of blocks of back drum brakes
2.3.14. Check of a condition of seat belts
2.3.15. Lubricant of door loops and locks
2.3.16. Check of the car in road conditions
2.4. Service through each 60000 km or 2 years
2.5. Service through each 60000 km or 12 months
3. Engines
4. Cooling system
5. System of heating and ventilation
6. Fuel and exhaust system
7. System of launch of the engine
8. Coupling
9. Transmissions
10. Half shafts
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment


2.3.10. Check of the exhaust system

1. Check a condition of the exhaust system, beginning from the engine to terminal section. Carry out check on the cold engine, not less than 1 hour later after a trip. For check it is the best of all to raise the engine to provide easy access to all details of system.
2. In the absence of the elevator lift the car and establish on supports.
3. Check existence on exhaust pipes and on connections of signs of leak of exhaust gases, strong corrosion and mechanical damages. Be convinced of reliability of fastening and integrity of all arms and support of exhaust pipes. Places of leak of exhaust gases can be found usually on a soot raid.
4. Strong knocks from the exhaust system are usually caused by unreliable fastening of exhaust pipes on arms and support. Shake pipes with mufflers. If pipes and mufflers come to contact with details of a suspension bracket or with the body bottom, then replace fastening details, or at an opportunity, separate pipes and turn them from each other to provide sufficient distance from other details.

2.3.9. Check of covers of half shafts

2.3.11. Check of angles of installation of wheels