Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
1. Maintenance instruction
2. Maintenance
2.1. Specifications
2.2. Service through each 15000 km or 6 months
2.3. Service through each 30000 km or 12 months
2.3.1. Check and replacement of belts of the drive of auxiliary units
2.3.2. Replacement of the fuel filter
2.3.3. Replacement of spark plugs (the car without Catholic converter)
2.3.4. Check of operation of the gate of a temperature regulator of the air filter
2.3.5. Check of system of decrease in toxicity of the fulfilled gases
2.3.6. Check of the sensor of exhaust gases
2.3.7. Replacement of brake fluid
2.3.8. Check of a suspension bracket and steering
2.3.9. Check of covers of half shafts
2.3.10. Check of the exhaust system
2.3.11. Check of angles of installation of wheels
2.3.12. Shift of wheels
2.3.13. Check of blocks of back drum brakes
2.3.14. Check of a condition of seat belts
2.3.15. Lubricant of door loops and locks
2.3.16. Check of the car in road conditions
2.4. Service through each 60000 km or 2 years
2.5. Service through each 60000 km or 12 months
3. Engines
4. Cooling system
5. System of heating and ventilation
6. Fuel and exhaust system
7. System of launch of the engine
8. Coupling
9. Transmissions
10. Half shafts
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







2-3-7-zamena-tormoznojj-zhidkosti.html

2.3.7. Replacement of brake fluid

PERFORMANCE ORDER
1. The procedure is similar to removal of air from a hydraulic actuator of brakes (see subsection 11.2). Before replacement of liquid it is necessary to suck away the fulfilled liquid from a nutritious tank a rubber pear or the syringe then to fill in fresh liquid. During removal of air from a contour of the brake highway, it is necessary to extort the fulfilled liquid.
2. Unscrew the first union for pumping of brakes (see subsection 11.2). Slowly press a brake pedal to remove the liquid remains from a nutritious tank.
3. Add fresh liquid to mark MOVE and continue to press a brake pedal so far fresh liquid will not begin to follow from the union. Wrap the union and add in a tank fresh liquid to mark MOVE.
4. Repeat this operation, serially turning off the others of the union of pumping and pressing a pedal up to one emergence fresher than liquid. Always support liquid level in a nutritious tank above the mark MIN, otherwise air because of what duration of pumping of brakes considerably will increase can get to the highway.
5. Upon termination of tighten the union and dress on them protective caps. Carefully wipe the remains of the spilled liquid and check level in a nutritious tank of the main cylinder of brakes.
6. Before a trip check work of brakes.


2.3.6. Check of the sensor of exhaust gases

2.3.8. Check of a suspension bracket and steering