Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
	1. Maintenance instruction
	2. Maintenance
		2.1. Specifications
		2.2. Service through each 15000 km or 6 months
		2.3. Service through each 30000 km or 12 months
			2.3.1. Check and replacement of belts of the drive of auxiliary units
			2.3.2. Replacement of the fuel filter
			2.3.3. Replacement of spark plugs (the car without Catholic converter)
			2.3.4. Check of operation of the gate of a temperature regulator of the air filter
			2.3.5. Check of system of decrease in toxicity of the fulfilled gases
			2.3.6. Check of the sensor of exhaust gases
			2.3.7. Replacement of brake fluid
			2.3.8. Check of a suspension bracket and steering
			2.3.9. Check of covers of half shafts
			2.3.10. Check of the exhaust system
			2.3.11. Check of angles of installation of wheels
			2.3.12. Shift of wheels
			2.3.13. Check of blocks of back drum brakes
			2.3.14. Check of a condition of seat belts
			2.3.15. Lubricant of door loops and locks
			2.3.16. Check of the car in road conditions
		2.4. Service through each 60000 km or 2 years
		2.5. Service through each 60000 km or 12 months
	3. Engines
	4. Cooling system
	5. System of heating and ventilation
	6. Fuel and exhaust system
	7. System of launch of the engine
	8. Coupling
	9. Transmissions
	10. Half shafts
	11. Brakes
	12. Suspension brackets and steering
	13. Body
	14. Electric equipment

2-3-13-proverka-kolodok-zadnikh-barabannykh-tormozov.html

2.3.13. Check of blocks of back drum brakes

PERFORMANCE ORDER

1. Block forward wheels, lift a back part of the car and establish on supports. Remove back wheels.

2. For check of wear of blocks of back brakes without removal of a drum get caps of viewing openings in brake boards. Examine forward blocks by means of a mirror, highlighting a small lamp. Make sure that thickness of blocks is not lower normal for what bring a bar to a slip of diameter of which it is equal to the extreme thickness of a slip (see subsection 2.1).

3. If residual thickness at least of one slip corresponds to standard value or exceeds this value, then replace all four brake shoes in a set.

4. If this way it is difficult to check thickness of brake slips or if more detailed check is required, then it is possible to remove brake drums and at the same time to check their state (see subsection 11.6).

2.3.12. Shift of wheels

2.3.14. Check of a condition of seat belts