Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. System of heating and ventilation
6. Fuel and exhaust system
7. System of launch of the engine
8. Coupling
9. Transmissions
10. Half shafts
11. Brakes
11.1. Specifications
11.2. Hydraulic actuator of brakes
11.3. Tubes and hoses
11.4. Blocks
11.5. Brake disk
11.6. Drums
11.7. Support of a forward brake
11.8. Support of a back brake
11.9. Wheel cylinder
11:10. Main cylinder
11:11. Brake pedal
11:12. Vacuum amplifier of brakes
11:13. Amplifier of brakes and backpressure valve
11:14. Lever of the emergency brake
11:15. Cables of the emergency brake
11:16. Adjustment of the emergency brake
11:17. Braking signal switch
11:18. Switch of a lamp of the emergency brake
11:19. Anti-blocking system
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







11-15-trosy-ruchnogo-tormoza.html

11:15. Cables of the emergency brake

CABLES OF BACK BRAKES

2 cables – left and right are provided.

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports.
2. Release the emergency brake.
3. On back drum brakes remove blocks and disconnect a cable from the lever, remove a spring and an arm of a cable (shooters specified brake arm nuts).
4. On back disk brakes get a bracket.
5. Disconnect a tip of a cable (shooter) from the support lever on back brakes.
6. Turn off nuts and bolts of fastening of arms of a cover of a cable to the bottom.
7. Disconnect a cable from a leveling roller in a forward part of the car and remove a cable.
8. For access to a roller it is required to remove a thermal guard.

Installation

PERFORMANCE ORDER
1. The cable is established upside-down.
2. The ledge on an arm of a cable has to come into dredging in a support
(disk brakes).
3. Adjust a cable.

CABLES OF FORWARD BRAKES

Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Block back wheels and release the emergency brake.
3. Remove the central section of the forward panel.
4. Disconnect the socket from the switch of a control lamp of the emergency brake.
5. Count quantity of strings of a carving to a nut, turn off a nut and disconnect an adjusting bolt from the brake lever.
6. Lift a forward part of the car.
7. Disconnect back cables from a leveling roller in a forward part of the car and remove a cable.
8. Remove forward cables with the equalizer and an adjusting bolt, having passed through an opening in a floor.

Installation

PERFORMANCE ORDER
1. The cable is established upside-down.
2. Turn off a nut on in advance counted number of strings of a carving, check work of a brake and if necessary adjust.
3. Before installation of the panel check serviceability of the switch and a control lamp.


11:14. Lever of the emergency brake

11:16. Adjustment of the emergency brake