Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. System of heating and ventilation
6. Fuel and exhaust system
7. System of launch of the engine
8. Coupling
9. Transmissions
10. Half shafts
11. Brakes
11.1. Specifications
11.2. Hydraulic actuator of brakes
11.3. Tubes and hoses
11.4. Blocks
11.5. Brake disk
11.6. Drums
11.7. Support of a forward brake
11.8. Support of a back brake
11.9. Wheel cylinder
11:10. Main cylinder
11:11. Brake pedal
11:12. Vacuum amplifier of brakes
11:13. Amplifier of brakes and backpressure valve
11:14. Lever of the emergency brake
11:15. Cables of the emergency brake
11:16. Adjustment of the emergency brake
11:17. Braking signal switch
11:18. Switch of a lamp of the emergency brake
11:19. Anti-blocking system
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







11-12-vakuumnyjj-usilitel-tormozov.html

11:12. Vacuum amplifier of brakes

Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. On carburetor engines the amplifier it is possible to remove without removing the soaking-up collector or the main cylinder.
3. On injector engines for access to the amplifier it is necessary to remove the soaking-up collector.
4. On carburetor engines remove the air filter (cm. subsection 6.1.2).
5. Disconnect wires from the sensor of pressure of the hydraulic booster, remove an arm of a hose of the hydraulic booster.
6. Remove the main cylinder from the vacuum amplifier.
7. Disconnect a hose from the vacuum amplifier.
8. Disconnect a pusher from a pedal and turn off four nuts of fastening of an arm to the amplifier.
9. Remove the amplifier from a motor compartment.

Prevention

Do not damage a carving of hairpins of the amplifier of brakes.


Installation

PERFORMANCE ORDER
1. The amplifier is installed upside-down.
2. Before installation check a pusher vystupaniye over the surface of the case of the amplifier.
3. On cars without ABS system adjust the provision of a pusher of the main cylinder, having exposed the size A.
4. The collector and the main cylinder are established in compliance with subsection 6.2.14 and subsection 11.10.
5. Upon termination of adjust a brake pedal.


11:11. Brake pedal

11:13. Amplifier of brakes and backpressure valve