|
12-11-rulevaya-kolonka.html
12:11. Steering column
Prevention
The present description does not belong to the cars equipped with a safety cushion.
Removal
| PERFORMANCE ORDER |
| 1. Disconnect the battery from weight. |
| 2. Remove a wheel. |
| 3. Remove switches with levers (cm. subsection 14.4). |
| 4. Disconnect the socket from the ignition switch. |
| 5. Remove the lower panel from the driver. |
| 6. Get and pull together a column sealant in a partition of a motor compartment. |
| 7. Remove a metal cover from a partition of a motor compartment, having turned off three nuts (on a part of cars). |
| 8. Dress a wheel and turn a shaft for access to a bolt of the cardan hinge. |
| 9. Turn off a hinge bolt. |
| 10. Turn off two top bolts and two lower nuts and remove a column. |
|
Check
| PERFORMANCE ORDER |
| 1. Check existence of deformation of a shaft, integrity of safety two-conical connection, if necessary replace a column. |
| 2. Check a condition of bearings and plugs, side plays of a shaft and hinges. |
| 3. At the slightest signs of wear and damages replace a column. |
| 4. Measure column length from an end face to a hinge pin. |
| 5. If length does not meet standard, then replace a column. |
|
Installation
| PERFORMANCE ORDER |
| 1. Put on a cover and a sealant a column, fix a sealant by a collar (if it is provided). |
| 2. Establish a column and enter into the cardan hinge so that the collar bolt at a wraparound rested against dredging on a shaft on the shlitsevy termination of a shaft. |
| 3. Tighten two top bolts and two lower nuts with the set moment. |
| 4. Tighten a bolt of the cardan hinge. |
| 5. Put on a cover and tighten three nuts (on a part of cars). |
| 6. Put on a cover a cover and fix by a collar. |
| 7. Install the lower panel. |
| 8. Attach the socket to the ignition switch. |
| 9. Install lever switches. |
| 10. Establish a wheel. |
| 11. Connect the battery to weight. |
|
| |