Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
	1. Maintenance instruction
	2. Maintenance
	3. Engines
	4. Cooling system
	5. System of heating and ventilation
	6. Fuel and exhaust system
		6.1. Carburetor engines
			6.1.1. Specifications
			6.1.2. Air filter
			6.1.3. Air stream temperature regulator
			6.1.4. Fuel pump
			6.1.5. Fuel level sensor
			6.1.6. Fuel tank
			6.1.7. Cable of the drive of a butterfly valve
			6.1.8. Pedal of management of a butterfly valve
			6.1.9. Fuel
			6.1.10. Carburetor
			6.1.11. Sensors and valves of the carburetor
			6.1.12. The soaking-up collector
			6.1.13. Final collector
			6.1.14. Exhaust system
		6.2. Engines with system of injection of fuel
		6.3. System of food / production of the fulfilled gases
		6.4. System of decrease in toxicity of the fulfilled gases
	7. System of launch of the engine
	8. Coupling
	9. Transmissions
	10. Half shafts
	11. Brakes
	12. Suspension brackets and steering
	13. Body
	14. Electric equipment

6-1-7-tros-privoda-drosselnojj-zaslonki.html

6.1.7. Cable of the drive of a butterfly valve

Removal

PERFORMANCE ORDER

1. Unhook a cable from a cam on the carburetor.
	2. Turn off cable cover nuts to an arm and get a cable cover from an arm (shooters showed adjusting nuts of a cable of a butterfly valve).
3. Release a cable on all route of laying.
4. In salon remove the lower panel from the driver.
5. Disconnect a cable from a pedal.
6. Turn off nuts of fastening of a cover to a partition of a motor compartment and get a cable, having stretched in a motor compartment.

Installation

PERFORMANCE ORDER

1. Pass a cable through a partition of a motor compartment.

2. Stretch a cable in a motor compartment and lay in the place.

3. Fix by nuts a cable cover on a partition of a motor compartment.

4. Attach a cable to a pedal.

5. Install the lower panel.

6. Fix a cable cover on all route.

7. Attach a cable to a cam on an axis of a butterfly valve.

8. Adjust a cable.

Adjustment

PERFORMANCE ORDER

1. Release adjusting nuts, be convinced that the cam rests against the limiter.

2. Tighten a distant nut as soon as the cam starts moving release a nut on 1,5–2 turns and tighten a lock-nut.

3. Ask the assistant to press a pedal and check smoothness of movement of a cam.