Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. System of heating and ventilation
6. Fuel and exhaust system
6.1. Carburetor engines
6.2. Engines with system of injection of fuel
6.3. System of food / production of the fulfilled gases
6.3.1. Models with single-point electronic injection of fuel Technical characteristics Air filter Accelerator rope Accelerator pedal The gasoline which is not containing tetraethyllead System of injection of fuel Fuel system Fuel pump Fuel level sensor Fuel tank Case of a butterfly valve System of injection of fuel / ignition Elements of system of injection of fuel Inlet collector
6.3.2. Models with multipoint electronic injection of fuel
6.4. System of decrease in toxicity of the fulfilled gases
7. System of launch of the engine
8. Coupling
9. Transmissions
10. Half shafts
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment

6-3-1-2-vozdushnyjj-filtr.html Air filter


1. Turn off and remove a bolt, and disconnect an air admission tube sideways of a casing of the air filter.
2. Turn off nuts of fastening of a cover of the air filter, then, release fixing clips and uncover.
3. Remove the filtering element.
4. Remove washers and elastic bands from bolts of a casing of the air filter, then, remove a fixing frame and consolidation.
5. Turn off and remove the remaining fixing bolts of a casing of the air filter, and get a casing from a motive compartment.
6. Disconnect all vacuum and air hoses from a casing of the air filter, having remembered or having marked the provision of their installation.
7. Then, it is possible to pick up the inlet phone and the resonator after all their fixing bolts are turned off. If it is necessary, the inlet tube can be disconnected from the resonator.
8. Examine plugs of fastenings and consolidation on existence of damages or wear tracks and replace them if it is necessary.


Installation is carried out upside-down removals. Check that all air ducts and hoses were correctly connected and were not pressed at installation of a casing of the air filter. Technical characteristics Accelerator rope