Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. System of heating and ventilation
6. Fuel and exhaust system
6.1. Carburetor engines
6.2. Engines with system of injection of fuel
6.3. System of food / production of the fulfilled gases
6.3.1. Models with single-point electronic injection of fuel Technical characteristics Air filter Accelerator rope Accelerator pedal The gasoline which is not containing tetraethyllead System of injection of fuel Fuel system Fuel pump Fuel level sensor Fuel tank Case of a butterfly valve System of injection of fuel / ignition Elements of system of injection of fuel Inlet collector
6.3.2. Models with multipoint electronic injection of fuel
6.4. System of decrease in toxicity of the fulfilled gases
7. System of launch of the engine
8. Coupling
9. Transmissions
10. Half shafts
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment

6-3-1-3-trosik-akseleratora.html Accelerator rope


1. Unhook a cable from a cam on the case of a butterfly valve.
2. Turn off cable cover nuts to an arm and get a cable cover from an arm (the arrow showed an adjusting nut of a cable of a butterfly valve).
3. Release a cable on all route of laying.
4. In salon remove the lower panel from the driver.
5. Disconnect a cable from a pedal.
6. Turn off nuts of fastening of a cover to a partition of a motor compartment and get a cable, having stretched in a motor compartment.


1. Pass a cable through a partition of a motor compartment.
2. Stretch a cable in a motor compartment and lay in the place.
3. Fix by nuts a cable cover on a partition of a motor compartment.
4. Attach a cable to a pedal.
5. Install the lower panel.
6. Fix a cable cover on all route.
7. Attach a cable to a cam on an axis of a butterfly valve.
8. Adjust a cable.


1. Release adjusting nuts, be convinced that the cam rests against the limiter.
2. Tighten a distant nut as soon as the cam starts moving release a nut on 1,5–2 turns and tighten a lock-nut.
3. Ask the assistant to press a pedal and check smoothness of movement of a cam. Air filter Accelerator pedal