Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. System of heating and ventilation
6. Fuel and exhaust system
6.1. Carburetor engines
6.2. Engines with system of injection of fuel
6.3. System of food / production of the fulfilled gases
6.4. System of decrease in toxicity of the fulfilled gases
6.4.1. Models with 1,4 and 1,6 liter engines
6.4.2. Models with 1,6 and 2,0 liter engines
6.4.2.1. System of decrease in emission of crankcase gases
6.4.2.2. Catalytic converter
6.4.2.3. The control system over release of vapors of fuel from fuel system
6.4.2.3.1. Coal filter
6.4.2.3.2. Thermal vacuum valve
6.4.2.3.3. Electromagnetic valve
6.4.2.4. System of recirculation of exhaust gases
6.4.2.5. System of thermal neutralization
6.4.2.6. System of an admission of air in a final collector
6.4.2.7. System of decrease in toxicity of exhausts
7. System of launch of the engine
8. Coupling
9. Transmissions
10. Half shafts
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment
 







6-4-2-3-2-termovakuumnyjj-klapan.html

6.4.2.3.2. Thermal vacuum valve

The thermal vacuum valve on models with the carburetor engine

The thermal vacuum valve (it is specified by an arrow) is located on the right side of an inlet collector.

Replacement

PERFORMANCE ORDER
1. The thermal vacuum valve is located on the right side of the inlet collector. The engine and an inlet collector have to be cold at removal of the valve.
2. Merge a part of cooling liquid from the cooling system (see subsection 2.4.5) in order that its level fell slightly below than the valve, or prepare a suitable cap to stop up an opening in an inlet collector after removal of the valve. If you decided to use a cap, try not to damage a collector and do not use anything of that kind that will allow foreign objects or substances to get to the cooling system.
3. Disconnect both hoses from the valve.
4. Accurately unscrew the valve from an inlet collector and remove a sealing ring (if it is established).
5. Installation is carried out upside-down removals. At installation use a new sealing ring (if it is necessary). If the sealing ring was not established on the valve, grease its carving with sealant before installation.


6.4.2.3.1. Coal filter

6.4.2.3.3. Electromagnetic valve