|
12-8-2-rychagi-zadnejj-podveski.html
12.8.2. Levers of a back suspension bracketRemoval
| PERFORMANCE ORDER |
| 1. Lift a back part of the car and establish on supports. |
| 2. Remove a wheel. |
|
3. Turn off axis nuts (are specified by an arrow) levers on the nave case. |
| 4. If levers change, then designate their situation, having applied tags on clowns of bolts of fastening of levers to arms of a body and on arms (clowns regulate a convergence of wheels). |
| 5. Turn off nuts of bolts of fastening of levers to a body, get the clown and a bolt. |
|
6. Remove levers (shooters specified nuts of bolts of fastening of levers to body arms). At removal remember an arrangement of bolts. |
|
Check
| PERFORMANCE ORDER |
| 1. Check a condition of levers and plugs. |
| 2. Levers change only assembled with plugs. |
|
Installation
| PERFORMANCE ORDER |
| 1. Install levers in arms and pass bolts, having established them in a former order. |
| 2. Put on washers and wrap new nuts. |
| 3. Insert an axis of levers from the back party of the case of a nave, dress washers and wrap new nuts. |
| 4. Establish a wheel and lower the car. |
| 5. Roll the car forward and back, shake up – down. |
| 6. Tighten a nut of an external axis of levers. |
|
7. Expose clowns on tags, check a convergence of back wheels and tighten nuts with the set moment (And – a negative convergence, In – a positive convergence, 1 – the right side, 2 – the left side). |
| 8. If the convergence cannot be checked, then tighten nuts then address on car repair shop. |
|
|
|