Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
	1. Maintenance instruction
	2. Maintenance
	3. Engines
	4. Cooling system
	5. System of heating and ventilation
	6. Fuel and exhaust system
	7. System of launch of the engine
	8. Coupling
	9. Transmissions
	10. Half shafts
	11. Brakes
	12. Suspension brackets and steering
		12.1. Specifications
		12.2. Bearings of naves of forward wheels
		12.3. Rack of a forward suspension bracket
		12.4. Lower lever
		12.5. Spherical support of the lower lever
		12.6. Stabilizer of cross stability of a forward suspension bracket
		12.7. Bearings of back wheels
		12.8. Details of a back suspension bracket
			12.8.1. Rack of a back suspension bracket
			12.8.2. Levers of a back suspension bracket
			12.8.3. Bars
			12.8.4. Nave case
			12.8.5. Stabilizer of cross stability of a back suspension bracket
		12.9. Wheel
		12:10. Switch of ignition and lock of blocking of a steering column
		12:11. Steering column
		12:12. Steering mechanism
		12:13. Covers of steering transfer
		12:14. Hydraulic actuator
		12:15. Pump of the hydraulic booster
		12:16. Tips of steering draft
	13. Body
	14. Electric equipment

12-8-4-korpus-stupicy.html

12.8.4. Nave case

Removal

PERFORMANCE ORDER

1. Lift a back part of the car and establish on supports.

2. Remove a wheel.

3. On cars with back disk brakes remove a disk and a support, without disconnecting a hose.

4. On cars with back drum brakes remove blocks and disconnect a tube from the cylinder.

5. Turn off a bar nut on the case of a nave and remove a washer.

6. Turn off nuts of an axis of levers on the nave case.

7. Turn off nuts of racks and remove the nave case.

Check

PERFORMANCE ORDER

Check a condition of the case, at detection of cracks and damages replace assembled with the bearing.

Installation

PERFORMANCE ORDER

1. Put on a bar the nave case.

2. Wrap new nuts of a rack and tighten with the set moment.

3. Attach levers and screw axis nuts.

4. Put on a washer and screw a new nut of a bar.

5. On cars with back drum brakes establish blocks and attach a tube.

6. Remove air from a hydraulic actuator.

7. On cars with back disk brakes establish a disk and a support.

8. Establish a wheel and lower the car.

9. Roll the car forward and back, shake up – down.

10. Tighten nuts with the set moment.

11. Check a convergence of back wheels.