Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. System of heating and ventilation
6. Fuel and exhaust system
6.1. Carburetor engines
6.2. Engines with system of injection of fuel
6.2.1. Specifications
6.2.2. Air filter
6.2.3. Cable of the drive of a butterfly valve
6.2.4. Pedal of management of a butterfly valve
6.2.5. Fuel
6.2.6. System of injection of fuel
6.2.7. Decompression of fuel system
6.2.8. Fuel pump
6.2.9. Fuel level sensor
6.2.10. Fuel tank
6.2.11. System of injection of fuel
6.2.12. Case of a butterfly valve
6.2.13. Units of system of injection of fuel
6.2.13.1. Distributor of fuel and nozzle
6.2.13.2. Pressure regulator
6.2.13.3. Sensor of a butterfly valve
6.2.13.4. Perepuskna air valve
6.2.13.5. Stream speed measuring instrument
6.2.13.6. The valve of correction of idling at change of load of the engine
6.2.13.7. The thermostat of the raised idling turns
6.2.13.8. Sensor of an angle of rotation of the crankshaft and transistor module
6.2.13.9. Sensor of temperature of cooling liquid
6.2.13.10. Processor block
6.2.13.11. Switch of neutral position of the check point
6.2.13.12. Switch of a starter and signal of the movement by a backing
6.2.13.13. Relay of the fuel pump and control unit
6.2.13.14. The switch of correction of idling during the operation of the hydraulic booster
6.2.13.15. The switch of correction of idling during the operation of the conditioner
6.2.13.16. Car speed sensor
6.2.14. The soaking-up collector
6.2.15. Final collector
6.2.16. Exhaust system
6.3. System of food / production of the fulfilled gases
6.4. System of decrease in toxicity of the fulfilled gases
7. System of launch of the engine
8. Coupling
9. Transmissions
10. Half shafts
11. Brakes
12. Suspension brackets and steering
13. Body
14. Electric equipment
 


6-2-13-14-pereklyuchatel-korrekcii-kholostogo-khoda-pri-rabote-gidrousilitelya.html

6.2.13.14. The switch of correction of idling during the operation of the hydraulic booster

The switch is screwed in a contour of the hydraulic booster in the right back part of a motor compartment.

Removal and installation

PERFORMANCE ORDER
1. Put wheels in driving position on a straight line and disconnect the battery from weight.
2. Disconnect the socket from the switch.
3. Unscrew the switch and muffle an opening in a tube, get a sealant.
4. At installation replace a sealant.

6.2.13.13. Relay of the fuel pump and control unit
6.2.13.15. The switch of correction of idling during the operation of the conditioner