Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
	1. Maintenance instruction
	2. Maintenance
	3. Engines
	4. Cooling system
	5. System of heating and ventilation
	6. Fuel and exhaust system
		6.1. Carburetor engines
		6.2. Engines with system of injection of fuel
			6.2.1. Specifications
			6.2.2. Air filter
			6.2.3. Cable of the drive of a butterfly valve
			6.2.4. Pedal of management of a butterfly valve
			6.2.5. Fuel
			6.2.6. System of injection of fuel
			6.2.7. Decompression of fuel system
			6.2.8. Fuel pump
			6.2.9. Fuel level sensor
			6.2.10. Fuel tank
			6.2.11. System of injection of fuel
			6.2.12. Case of a butterfly valve
			6.2.13. Units of system of injection of fuel
				6.2.13.1. Distributor of fuel and nozzle
				6.2.13.2. Pressure regulator
				6.2.13.3. Sensor of a butterfly valve
				6.2.13.4. Perepuskna air valve
				6.2.13.5. Stream speed measuring instrument
				6.2.13.6. The valve of correction of idling at change of load of the engine
				6.2.13.7. The thermostat of the raised idling turns
				6.2.13.8. Sensor of an angle of rotation of the crankshaft and transistor module
				6.2.13.9. Sensor of temperature of cooling liquid
				6.2.13.10. Processor block
				6.2.13.11. Switch of neutral position of the check point
				6.2.13.12. Switch of a starter and signal of the movement by a backing
				6.2.13.13. Relay of the fuel pump and control unit
				6.2.13.14. The switch of correction of idling during the operation of the hydraulic booster
				6.2.13.15. The switch of correction of idling during the operation of the conditioner
				6.2.13.16. Car speed sensor
			6.2.14. The soaking-up collector
			6.2.15. Final collector
			6.2.16. Exhaust system
		6.3. System of food / production of the fulfilled gases
		6.4. System of decrease in toxicity of the fulfilled gases
	7. System of launch of the engine
	8. Coupling
	9. Transmissions
	10. Half shafts
	11. Brakes
	12. Suspension brackets and steering
	13. Body
	14. Electric equipment

6-2-13-2-regulyator-davleniya.html

6.2.13.2. Pressure regulator

Removal and installation

PERFORMANCE ORDER

1. Disconnect the battery from weight.
	2. Disconnect a vacuum tube (shooter) from pressure regulator.
3. Execute a decompression of fuel system and disconnect a fuel hose from the regulator.
4. Turn off two bolts and remove the regulator and laying.
5. Installation is carried out upside-down.
6. At assembly replace laying.

6.2.13.1. Distributor of fuel and nozzle

6.2.13.3. Sensor of a butterfly valve