Service of Nissan Sunny from 1991 to 1997 release in n-14 body.
1. Maintenance instruction
2. Maintenance
3. Engines
4. Cooling system
5. System of heating and ventilation
6. Fuel and exhaust system
7. System of launch of the engine
8. Coupling
9. Transmissions
10. Half shafts
11. Brakes
12. Suspension brackets and steering
13. Body
13.1. Specifications
13.2. Maintenance
13.3. Small damages of a body
13.4. Large damages of a body
13.5. Front bumper
13.6. Rear bumper
13.7. Cowl
13.8. Cowl lock drive cable
13.9. Cowl lock
13:10. Doors
13:11. Internal panel of a door
13:12. Door lock, switch of the lock and detail of the handle
13:13. Glass of a door and window regulator
13:14. Trunk lid (sedan)
13:15. Cover of a cargo compartment (compartment and hatchback)
13:16. Lock of a trunk lid (sedan)
13:17. Lock of a cover of a cargo compartment and handle
13:18. Details of the central lock
13:19. External glasses
13:20. Windshield, back glass and stationary glasses
13:21. Hatch
13:22. Decorative overlays of a body
13:23. Seats
13:24. Panels of facing of salon
13:25. Average section of the forward panel
13:26. Details of forward facing of salon
14. Electric equipment


13:10. Doors

Removal and installation

1. Disconnect the battery from weight.
2. Remove the internal panel of a door (see subsection 13.11).
3. Disconnect all sockets, designate the route of conducting and get from brackets.
4. Carefully extend conducting from door openings, having got a sealant.
5. Beat out an axis of the limiter of opening of a door.
6. Designate the provision of loops on a door.
7. Supporting a door, turn off bolts of loops and remove a door.
8. Check a condition of loops, if necessary replace, having turned off bolts on a body.
9. Coupling guard.
10. The lower bolts of fastening of a case of coupling to the block of cylinders.
11. The door is established upside-down on the put tags. Replace a limiter axis. If necessary adjust a door.


1. Carefully close a door, check gaps between the next panels.
2. The door is regulated by movement in openings of loops of a door and a body at the released bolts. After adjustment tighten bolts.
3. Check adjustment of the door lock, if necessary adjust movement of a clamp on a body rack at the released bolts which after adjustment tighten.

13.9. Cowl lock

13:11. Internal panel of a door

(adsbygoogle = window.adsbygoogle || []).push({});